Beninca YK Sliding Autogate Repair in Ampang – Industrial Sliding Gate Motor Repaired

 

Recently, Mr. Alex and the Dr Autogate team were called to a factory in Ampang to repair a Beninca YK industrial sliding autogate system.This was a large factory gate with a double sliding gate design. One gate slides to the left while the other slides to the right. The problem was on the left side, where the gate would open halfway and then stop.

Although the gate on the right side was still working, the factory was facing difficulties because the entire system was no longer operating as smoothly as before. For factories and warehouses, even a small autogate problem can affect daily operations and vehicle access.

The customer told us that the original installer was no longer supporting this type of industrial autogate system. They had also contacted a few autogate contractors, but most were more familiar with residential autogates and did not have much experience with heavy-duty industrial sliding gates.

After receiving the call, our technicians arrived on site with the necessary tools and spare parts. We carried out a full inspection to identify the exact cause of the problem. Fortunately, the Beninca motor gearbox was still in good condition. After further testing, we found that the issue was caused by a faulty control board. Once the damaged F5 control board was replaced, the autogate started operating normally again. The gate was able to open and close smoothly, and the factory could continue its daily operations without further interruption.

 

 

Beninca Autogate Repair Specialist

 

Beninca is a popular autogate brand from Italy and is widely used in both residential and industrial properties. These systems are known for their reliability and durability, especially in locations where the gate is used frequently every day.

However, like any electrical or mechanical system, autogates may develop problems over time. Common issues include faulty control boards, motor problems, damaged wiring, sensor failures, and remote control issues.

At Dr Autogate, we provide repair, servicing, maintenance, and spare parts support for Beninca autogate systems. Because we keep many common spare parts ready, we are often able to complete repairs faster and minimise downtime for our customers.

 

 

 

Nearly 30 Years of Autogate Experience

 

With almost 30 years of experience in the autogate industry, Mr. Alex and the Dr Autogate team have handled a wide range of autogate systems throughout Klang Valley.

From residential swing gates to large factory sliding gates, our team understands the different challenges involved in repairing and maintaining gate automation systems. Industrial autogates are usually much larger and heavier than residential gates. They are also used more frequently, which means proper installation, maintenance, and repair work are very important for long-term reliability.

Over the years, we have successfully repaired many different brands and types of autogate systems. No matter the brand or model, our goal is always the same to provide a practical, reliable, and cost-effective solution for every customer.

 

Need Industrial Autogate Repair in Ampang?

 

If your factory autogate is not working properly, simply take a few photos of the gate and motor system and send them to us through WhatsApp. Our team will review the problem and arrange a suitable time for inspection and repair.

Whether it is an industrial sliding gate, factory autogate, warehouse gate, or residential autogate system, Dr Autogate is ready to help.

Need autogate repair, maintenance, or a new installation? Contact Dr Autogate at 012 – 295 6299 today and let Mr. Alex and his experienced team assist you.