Dnor Autogate System Failed Again in Ampang

 

Today we received a call from a customer in Ampang facing a serious issue. His Dnor 712 autogate could not open at all, whether using the remote control or the switch inside the house. From the initial description, we suspected a problem with the autogate control panel. However, the customer told us the control board had just been replaced one month ago. According to him, the previous installer said the board was damaged by lightning, so he paid for a replacement even though the system was still under warranty.

But after only two months, the autogate failed again. This is unusual, because a new autogate motherboard should not fail so quickly. The customer tried to contact the previous installer, but unfortunately, they were no longer reachable. Since the autogate could not be used, he contacted Dr Autogate, recommended by his friend.

 

 

 

 

“New” Autogate Control Board – Actually a Used Part

 

When our technician arrived and performed a full inspection on the Dnor 712 autogate, we discovered that the real issue was not just a normal control panel failure. The IC board inside the panel was already damaged. After checking carefully, we noticed something unusual. The board did not look new at all. The physical condition clearly showed signs of an old, used part. When we explained this to the customer, he was shocked. He had paid for a “new” control board just two months ago.

From our experience, this situation is quite common when dealing with unreliable or inexperienced autogate contractors. Some may claim to replace with new parts, but actually install used autogate motherboards taken from other sites. This helps them reduce cost, but causes serious problems for customers later. That is why it is very important to choose a trusted autogate service provider and always make sure the parts are genuinely new before installation.

 

Proper Repair with Genuine New Parts

 

To solve the issue, we replaced the faulty board and control panel with a brand new, high-quality PCB board. All parts we use are sourced from trusted suppliers and come with proper assurance. After installation and testing, the Dnor 712 autogate was fully working again. The gate could open and close smoothly using both remote control and switch. The customer was relieved that the problem was finally solved properly, without worrying about repeated failure.

 

 

 

Choose Reliable Autogate Service in Ampang

 

Dnor is a good quality autogate system, but proper installation and genuine parts are very important. Without that, even a good system can fail. This case is a good reminder for all autogate owners. Do not simply trust when someone says “new parts” without proof. Always choose experienced and reliable autogate specialists.

At Dr Autogate, we focus on honest work, proper diagnosis, and using original parts. We make sure every job is done carefully so customers can feel confident and satisfied.

 

Professional Autogate Services by Dr Autogate

 

We provide complete autogate repair and installation services in Ampang and Klang Valley. Whether it is swing arm, folding arm, or sliding autogate, we are ready to help. If your autogate has problems, you can easily get help in 3 simple steps. Take a few photos of your autogate and motor, send them to us via WhatsApp, and we will arrange a service time with you.

For fast and reliable autogate service, contact Mr Alex at 012-295 6299 or WhatsApp: https://wa.me/60122956299

If you are planning to install or repair your autogate, just call Dr Autogate today.