Dr Autogate – Gate and Autogate Motor Repair Specialist

Not all autogate contractors in Klang Valley can solve autogate problems completely. Many only focus on repairing the motor but do not handle gate structure issues such as bearing replacement, wheel damage, hinge problems, or track misalignment.

At Dr Autogate, we provide a complete one-stop autogate solution from motor repair to full gate alignment and bearing replacement. When a gate bearing is worn out or the gate becomes uneven, the autogate motor must be properly adjusted and realigned. If not adjusted correctly, the motor will carry heavy load, causing slow movement, jerking, or long-term damage.

That is why choosing an experienced autogate specialist is important. We understand the full gate and autogate system, not just one part of it.

Repair Autogate Not Fully Closing in Shah Alam

A customer in Shah Alam contacted us because their swing autogate could not close fully. One side of the gate had slightly dropped, causing uneven alignment. After inspection, we found that the main cause was faulty gate bearings. The customer had previously contacted several contractors, but most only repaired autogate motors and did not handle gate structural repairs such as bearing replacement.

Dr Autogate resolved the issue with the following steps:
Step 1: Replaced two units of gate bearings at the upper and lower section.
Step 2: Re-aligned and leveled the swing gate properly.
Step 3: Diagnosed a remote control issue caused by a faulty 330MHz receiver.
Step 4: Upgraded the system to a 433MHz remote receiver and supplied three new remote controls.

After proper adjustment and testing, the swing autogate operated smoothly again with stable opening and closing.

Swing Autogate Services in Shah Alam and Klang Valley

We provide complete swing autogate repair services including:

• Gate bearing replacement
• Gate realignment and leveling
• Remote control repair and upgrade
• Motor and arm servicing
• Motherboard replacement
• Track and wheel repair 

All repairs are completed on-site using proper tools and quality spare parts to ensure long-lasting performance.

 

 

 

What Makes Dr Autogate Different

 

The difference between Dr Autogate and other contractors is simple. We solve the problem completely. We do not just repair the motor. We inspect the entire system including the gate structure, bearings, hinges, wheels, track, motor performance, control board, and wiring.

Our experienced technicians can quickly identify the root cause and fix it in a single visit. This saves time, reduces repeated breakdowns, and ensures your autogate runs smoothly and safely. We carry a wide range of spare parts during service visits so most repairs can be completed immediately. We also install new autogate systems including trusted brands like. Tronica to ensure reliable performance from the beginning.

 

 

New Autogate Installation

 

At Dr Autogate, we provide complete autogate installation for both swing and sliding gates. Every installation is handled by experienced technicians with proper gate alignment, motor balancing, wiring setup, and system calibration. This ensures smooth and stable operation, reduced motor stress, longer system lifespan, and safe daily usage.

We make sure your autogate works correctly from day one with no shortcuts and no improper setup.
Call Dr Autogate 012 295 6299 today for fast, professional, and reliable autogate service in Klang Valley.

Just call Dr Autogate. We handle the rest.